HEIDENHAIN MANUALPLUS 620 - Page 1600

1600 HEIDENHAIN Technical Manual MANUALplus 620
 Select MP_lockValue (optional);
If the value entered in the column equals the value given here, the text in
MP_text is displayed. It can no longer be edited. This way editing can be
disabled depending on the value.
 Select MP_value (optional); enter the value for MP_dialog.
 Select MP_dialog (optional);
 (MP_dialogRes in preparation);
 Select MP_text (optional); enter the text for MP_value.
(keep MP_width in mind)
 Select CfgColumnText; enter the dialog text for the columns.
 Carry out the above procedure for all new columns, and save the information
with the SAVE soft key.
The following machine parameters are used for defining the columns.
MP_width
Column width
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 2 to 50 (column width of max. 50 characters)
Default: 2
Access: LEVEL3
Reaction: NOTHING