January 2012 9.4 The USB Interface of the Control (USB 2.0) 1765
USB devices on the 
control
The USB interface of the control allows for convenient and fast exchange of 
data. You can connect USB block devices, such as memory sticks, hard disks, 
CD-ROM drives, to your control via the USB interface without having to reboot 
the system. The data media can be accessed immediately after connection.
The control supports the following USB block devices:
 Floppy disk drives with the FAT/VFAT file system
 Memory sticks with the FAT/VFAT file system
 Hard disks with the FAT/VFAT file system
 CD-ROM drives
The control does not support USB devices with other file systems (e.g. NTFS). 
If you try to connect such devices, the control will issue an error message.
USB devices tested 
by HEIDENHAIN
A variety of USB storage media from different manufacturers is available on 
the market. It may happen that a USB device is not identified correctly by the 
control. The USB devices listed in the table below were tested by 
HEIDENHAIN for proper functioning in conjunction with the control (numerous 
other USB devices are supported by the control, but you should test them for 
proper functioning on the control before using them):
It should basically be possible to connect all USB block devices with the 
above-mentioned file system to the control. If you nevertheless encounter 
problems, please contact HEIDENHAIN.
USB device Manufac-
turer
Model designation VendorID ProductID Revision
Floppy disk drive TEAC TEAC FD-05PUW 0644 0000 0.00
Floppy disk drive TEAC TEAC FD-05PUB 0644 0000 0.00
CD-ROM drive TEAC USB CD-ROM 210 PU 0644 1000 1.33
CD-ROM drive FREECOM USB2-IDE Controller 07ab fc02 11.10
Hard disk UNKNOWN USB to IDE Converter 05e3 0702 0.02
Memory stick TrekStor USB MiniStick 0c76 0007 1.00
Memory stick QDI UNKNOWN 0c76 0005 1.00
Memory stick Transcend TS512MJFLASH 058f 9380 1.00
Memory stick Transcend Flash Disk 0ea0 2168 2.00
Memory stick Generic Mass Storage Device 058f 9384 1.05