HEIDENHAIN MANUALPLUS 620 - Page 352

352 HEIDENHAIN Technical Manual MANUALplus 620
If configuration objects are to be added or deleted during a software update,
then you must define a command for this action in the update rules. You can
call the update rules function to view all previous changes to the
configuration made with update rules.
These rules no longer need to be followed once the software has been
exchanged (see "NC software exchange on the MANUALplus 620" on page
137).
Using update rules You must save update rules in a file with the extension .cfg.
 Ensure that a file with the name PLC:\config\[update rule].cfg exists on
the control.
 Enter the Machine Parameters mode of operation, and use the CONFIG FILE
LISTS soft key to enter the path to the [update rule].cfg file as described
below:
 Edit the [update rule].cfg file with an ASCII editor, such as Notepad or
UltraEdit32. The following pages describe the available commands.
Settings under CONFIG FILE LISTS
CfgConfigDataFiles
updateFiles
[0]: %oemPath%\[update
rule].cfg