HEIDENHAIN MANUALPLUS 620 - Page 390

390 HEIDENHAIN Technical Manual MANUALplus 620
Supplementary explanations for calling Modules 9430 to 9433, 9436 and 9438:
Entries for PS/PL Description of the module entries
<Name of the
configuration
object>
Name of the folder in the machine configuration (=
config object or entity), in which the machine
parameter to be changed is located;
e.g.: "CfgOemBool"
<Key name> Key name where the object is located; e.g.
"CH_NC".
Key names are used to structure the machine
configuration – they gather associated areas
together, such as a machining channel ("CH_NC") or
the parameter set of an axis ("PX").
Transfer an empty string for parameters without
key names.
<Name of the
machine
parameter>
Name of the machine parameter (attribute) that is
to be changed;
e.g.: "swLimitSwitchPos"
<Index> Index within an array (list field);
Enter 0 for parameters without an array
<Factor> Division factor for conversion to a floating-point
number
Enter 1 to receive integer parameters
<Value of the
machine
parameter>
Value of the parameter, e.g.: 123456
<String> String number (0 to 15)
<Errors> See "Return codes of PLC Modules 9430 to 9433,
9436, 9438 (error stack)" on page 397.