January 2012 4.10 List of Machine Parameters 469
readonly
105608
(optional parameter)
Write protection on column entry
If the attribute is set to TRUE, the value assigned
when inserting the line cannot be changed. If the
attribute is not set or set to FALSE, values may be
overwritten.
Format: Selection menu
Input:
TRUE:
Values are write-protected
FALSE:
Values may be overwritten
Default: FALSE
PLC/Pgm
run is
locked
LEVEL3
1604
unitIsInch
105609
(optional parameter)
Column entry in inches
If lengths and feed rates are to be specified in the
column in a definite unit of measure, enter TRUE
here for values in inches and FALSE for values in
mm. If the parameter is not set, the unit of
measure is taken from the corresponding table.
Format: Selection menu
Input:
TRUE:
Column entry in inches
FALSE:
Column entry in mm
PLC/Pgm
run is
locked
LEVEL3
1604
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page
To Next Page
Loading...
