HEIDENHAIN MANUALPLUS 620 - Page 49

January 2012 1.1 Hardware 49
Service Operation of the new UEC 11x on the MANUALplus 620 with HSCI may
require the installation of a service pack or upgrading the NC software to a
newer software version.
Dimensions
Note
NC software 548 328-03 or higher is required for operating the new UEC
11x (variant 03) with the MANUALplus 620!
280
433
100±0.2 24.75
10
7
456 480
5.5
149.5
¬ 12