January 2012 1.3 NC Software 548 328-04 55
Checking machine
parameters
If you use a coded spindle on your MANUALplus 620, you must check the
setting of MP_axisMode (300105) and change it, if necessary.
Until now, it was allowed to set MP_axisMode = active for a spindle with
encoded output of the spindle speed. Now this setting is not allowed
anymore. Check the setting of the encoded spindle and change the value to
MP_axisMode = PlcControlled, if necessary.
You also need to copy the apimarker.def file to your PC, and add it to the
PLCdesignNT project. Otherwise, during the next transfer of PLC project
files to the control, the file might be overwritten by the old version.
Please note the following important information if you are using the NCK-
Turn-V04-04 HEIDENHAIN PLC basic program in conjunction with the NC
software 548 328-04.
After an update, please modify the previous file plc_attr.cfg as described
below, and add it to the PLCdesignNT project. Otherwise, during the next
transfer of PLC project files to the control, the file plc_attr.cfg might be
overwritten by the old version, which leads to the multiple error 140-0033
"Job cannot run."
To Next Page
Loading...
