HEIDENHAIN MANUALPLUS 620 - Page 627

January 2012 6.3 Configuration of Axes 627
Properties of the
linear axes U, V, W
The additional axes U, V and W are parallel linear axes.
They are parallel coordinates for programming in the editor.
Standard
coordinates
The meanings of the coordinates X, Y, Z, A, B, C, U, V and W are specified in
DIN 66 217.
The MANUALplus 620 views coordinates whose MP_axName parameter
begins with X, Y, Z, A, B, C, U, V or W as standardized coordinates.
For these standardized coordinates, the parameters of the object
CfgProgAxis must obey the following rules:
+Y
+X
+U
+V
+W
+Z
First letter of parameter
MP_axName
Parameter
MP_dir
Parameter MP_progKind
X XAxis MainLinCoord
Y YAxis MainLinCoord
Z ZAxis MainLinCoord
U XAxis ParallelLinCoord
V YAxis ParallelLinCoord
W ZAxis ParallelLinCoord
A XAxis ParallelAngCoord
B YAxis ParallelAngCoord
C ZAxis ParallelAngCoord