640 HEIDENHAIN Technical Manual MANUALplus 620
MP_advancedSettings
Advanced settings for individual axes
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: Bit-encoded advanced axis settings
Max. 32 bits available, of these currently supported:
Bit 0 = 1:
A traverse commanded by the PLC is not interrupted if the
touch probe is deflected.
Bit 1 = 1:
A traverse commanded by the PLC is not made in a bell-shaped
curve but at a constant acceleration.
Bit 2 = 1:
For a spindle in position feedback control, the following error is
not calculated in modulo counting mode.
Default: No value, parameter optional (= all bits = 0)
Access: LEVEL3
Reaction: RUN
To Next Page
Loading...
