828 HEIDENHAIN Technical Manual MANUALplus 620
MP_pathTolerance
Path tolerance for contour transitions after the filter
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0.0001 to 10.000 000 000 [mm]
Default: 0.01 [mm]
Access: LEVEL3
Reaction: RUN
MP_pathToleranceHi
Path tolerance after the filter at rapid traverse
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0.0001 to 10.000 000 000 [mm]
Default: 0.01 [mm]
Access: LEVEL3
Reaction: RUN
All "-Hi" parameters (jerk and tolerance) go into effect from the feed rate
defined in MP_maxG1Feed.
Please note:
Programmed feed rate <= MP_maxG1Feed:
Tool in contact with workpiece, lower jerk values and tolerances are
effective
Programmed feed rate > MP_maxG1Feed:
Rapid traverse, greater jerk values and tolerances are effective
MP_maxG1Feed
Maximum machining feed rate. If this value is exceeded, the "–
Hi" parameters go into effect.
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0.000 000 000 to 99 999 [mm/min]
Default: 99 999 [mm/min]
Access: LEVEL3
Reaction: RUN
HEIDENHAIN recommends:
Set MP_maxG1Feed to a high value when optimizing the machine. This
prevents inadvertent use of the "-Hi" values on the MANUALplus 620 while
you are adjusting the axes.
To Next Page
Loading...
