HEIDENHAIN MANUALPLUS 620 - Page 836

836 HEIDENHAIN Technical Manual MANUALplus 620
Reduction of the
contouring feed
rate at the
beginning of a
contour element
The new, optional parameter MP_reduceCornerFeed was introduced with
NCK software version 597 110-05 (MLST 5) With this parameter you can
activate or deactivate a reduction of the contouring feed rate at the beginning
of any contour element.
The setting MP_reduceCornerFeed = TRUE reduces the contouring feed rate
at the beginning of a contour element. This may improve the accuracy, but also
results in a longer machining time.
If a short machining time is more important than high accuracy, you should set
MP_reduceCornerFeed to the value FALSE. This way the contouring feed rate
at contouring elements is not reduced and the machining time is shorter.
MP_reduceCornerFeed
Reduction of the contouring feed rate at the beginning of a
contour element
Available from NCK software version: 597 110-05.
Format: Selection menu
Selection: TRUE
Reduction of contouring feed rate active
(slower but more accurate if required)
FALSE
Reduction of contouring feed rate not active
(fast, but can be a little less accurate)
Default: TRUE
Access: LEVEL3
Reaction: RUN
Settings in the configuration editor MP number
Channels
ChannelSettings
[Key name of the machining channel]
CfgLaPath
reduceCornerFeed 201516