872 HEIDENHAIN Technical Manual MANUALplus 620
With the CC 61xx or CC 424 you can also use this function without active IPC.
A prerequisite for the activation of the possibility of compensation with the
CC 422 is an active and already adjusted IPC (Integral Phase Compensation).
Commissioning:
Enter the following test program:
BEARBEITUNG [MACHINING]
[maximum traverse range]
N1 G0 X400
N2 G0 X0
N3 M99
END
Run the program at high speed.
Use the integrated oscilloscope to record the following error.
CC 424: Adjust MP_compIpcJerkFact until a minimal following error occurs
in the jerk phase. Here you can compensate the following error for the jerk
phase.
Typical input values: 0 to 0.5 (e.g. 0.01).
CC 422: Adjust MP_compIpcJerkFact until a minimal following error occurs
in the jerk phase. Here you can compensate positive following errors
(MP_compIpcJerkFact > 1) as well as rare negative following errors
(MP_compIpcJerkFact < 1) for the jerk phase.
Typical input values: 0.5 to 2.
MP_compIpcJerkFact
Following error in the jerk phase
Available from NCK software version: 597 110-02.
Format: Numerical value
Input: 0.000 000 000 to 10
Default: 0
Access: LEVEL3
Reaction: RUN
Please note that values over 0.5 in MP_compIpcJerkFact do not make
sense for the CC 424 controller unit, and are therefore not permissible.
Therefore, an error message will be issued for values greater than 0.5.
To Next Page
Loading...
