Setting MP_ampBusVoltage has been made and
MP_ampVoltProtection = "not installed – mode 3"
Max. Inoml < 70 %
of maximum current?
MP_ampVoltProtection = "not
installed – mode 3" (8); end
YES
Reduction of acceleration and/or jerk
Measurement of the actual current
No
Setting of jerk and acceleration (at
maximum load and maximum feed
rate)
Alternative
Max. actual current < 90 %
of maximum current?
YES
No
MP_ampVoltProtection = "not installed – mode 5" (10)
Max. actual current < 90 %
of maximum current?
YES
Reduction of acceleration and/or jerk (12)
No
Measurement of the actual current
MP_ampVoltProtection = "not
installed – mode 3" (9); end
MP_ampVoltProtection = "not
installed – mode 3" (10); end
To Next Page
Loading...
