Icom IC-7100

10
GPS/GPS-A OPERATION
10-9
Adding or editing GPS memory (Continued)
4. GPS memory time programming
!4 Touch “TIME:” to enter the time programming mode.
!5 Touch or hold down [+] or [-] under the changing sub-
ject between Hour, Minute, and Second to program
the time.
• You can also change by using the dial.
• From 00:00:00 to 23:59:59 can be programmed.
!6 When the programming is completed, touch [](D)
to return to the “GPS MEMORY EDIT” screen.
q
w
q
5. GPS latitude programming
!7 Touch “LATITUDE:” to enter the latitude programming
mode.
!8 Enter the desired latitude using the touch screen
• From 0˚00.00' to 90˚00.00' can be programmed.
• If “ddd° mm' ss"” is selected in “Position Format” screen,
between 0°00'00" to 90°00'00" are programmable.
GPS > GPS Set > Position Format
!9 Touch [f](D) or [g](D) to move the cursor backward
and forward.
• Touch “N/S” to select “N” to program the north latitude,
and “S” to program the South latitude.
@0 Repeat steps !8 and !9 to program the latitude.
@1 When programming is completed, touch [ENT](D) to
return to the “GPS MEMORY EDIT” screen.
6. GPS longitude programming
@2 Touch “LONGITUDE:” to enter the longitude programming
mode.
@3 Enter the desired longitude using the touch screen.
• From 0˚00.00' to 180˚00.00' can be programmed.
• If “ddd° mm' ss"” is selected in “Position Format” screen,
between 0˚00'00" to 180˚00'00" are programmable.
GPS > GPS Set > Position Format
@4 Touch [f](D) or [g](D) to move the cursor backward
and forward.
• Touch “E/W” to select “E” to program the East longitude,
and “W” to program the West longitude.
@5 Repeat steps @3 and @4 to program the longitude.
@6 When programming is completed, touch [ENT](D) to
return to the “GPS MEMORY EDIT” screen.
q
w
q
w
q
w
Previous view