Juniper QFX Series - Planning QFX3100 Power Requirements; AC Power Specifications for a QFX3100 Director Device

mode CLI command show interfaces diagnostics optics. The command does not give any
output for copper transceivers or transceivers not purchased from Juniper Networks.
The three tables in this topic describe the optical interface support over single-mode
fiber-optic (SMF) and multimode fiber-optic (MMF) cables and copper interface support
over four-pair, Category 5 shielded twisted-pair cables:
•
Table 32 on page 110—Copper interface support and optical interface support for
Gigabit Ethernet SFP transceivers.
•
Table 33 on page 113—Optical interface support for Fibre Channel SFP+ transceivers.
•
Table 34 on page 114—Optical interface support for 10-Gigabit Ethernet SFP+
transceivers.
NOTE: For information about the SFP+ direct attach copper (DAC) cables
that are supported on the QFX3500 device, see “Interface Specifications for
SFP+ DAC Cables for QFX3500 Device Access Ports” on page 117. For
information about the QSFP+ tofourSFP+ breakout cablesthat are supported
on the QFX3500device, see InterfaceSpecifications for QSFP+ DAC Breakout
Cables for QFX3500 Device Uplink Ports.
109Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Port and Interface Specifications