Juniper QFX Series User Manual

CAUTION: QFX3100 Director devices are maximally protected inside the
shipping carton. Do not unpack the Director devices until you are ready to
begin installation.
To unpack a QFX3100 Director device (see Figure 56 on page 214):
1. Move the shipping carton to a staging area as close to the installation site as possible
but where you have enough room to remove the system components.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Remove the accessory box and verify the contents against the parts inventory.
5. Pull out the packing material holding the QFX3100 Director device in place.
6. Verify the components received against the inventory provided in Table 55 on page 214.
7. Save the shipping carton and packing materials in case you need to move or ship the
device later.
Figure 56: Unpacking a QFX3100 Director Device
Table 55: Inventory of Components Provided with a QFX3100 Director Device
QuantityComponent
1QFX3100 Director device
Copyright © 2012, Juniper Networks, Inc.214
QFX3000 Hardware Documentation

Juniper QFX Series Specifications

General

Category	Switch
Series	QFX
Form Factor	1U, 2U, and modular chassis options
Power Supply	Redundant, hot-swappable power supplies
Cooling	hot-swappable fans
Virtual Chassis	Supported on certain models
Typical Use	Data center, cloud
Operating System	Junos OS
Management	CLI
Key Features	High performance, low latency, automation
Latency	Sub-microsecond latency
Port Density	Varies by model (e.g., QFX5100: up to 48x10GbE + 6x40GbE)