Table 58: QFX3008-I Interconnect Device Accessory Kit Document Contents (continued)
Documents
RoHS Compliance and Warranty Information Card
Table 59: Wiring Tray Accessory Kit Part Contents
QuantityParts
2 (delta or wye three-phase wiring trays only)Strain relief connector
2 (delta or wye three-phase wiring trays only)90-degree connector
6 (single-phase wiring trays only)Power cords
NOTE: You must provide mounting screws that are appropriate for your rack
or cabinet to front-mount the chassis in a rack or a cabinet. The spacer bars
are attached to the chassis for shipment using 14 mounting screws. These
screws can be reused during installation.
For four-post rack installation, you need 36 screws:
•
6 screws to attach the small mounting shelf to the rear of the rack
•
4 screws to attach the large mounting shelf to the front of the rack
•
12 screws to attach the spacer bars to the front of the rack
•
14 screws to attach the front-mounting brackets (“ears”) that come
installed on the chassis to the front of the rack
For two-post rack installation, you need 46 screws:
•
6 screws to attach the small mounting shelf to the front of the rack
•
22 screws to attach the large mounting shelf to the rear of the rack
•
18 screws to attach the center-mounting brackets (“ears”) that come
installed on the chassis to the front of the rack
Related
Documentation
Unpacking a QFX3008-I Interconnect Device on page 224•
• QFX3008-I Interconnect Device Overview on page 33
Installing QFX3008-I Interconnect Device Mounting Hardware on Four-Post Racks or
Cabinets
Before you install the QFX3008-I Interconnect device in a four-post rack or cabinet, you
must first install mounting hardware and remove the center-mounting brackets from
the chassis (see Figure 60 on page 228).
227Copyright © 2012, Juniper Networks, Inc.
Chapter 19: Installing a QFX3008-I Interconnect Device
To Next Page
Loading...
Need help?
General
