Juniper QFX Series - Connecting QFX3100 Director Devices to the Control Plane Network

To connect QFX3100 Director devices in a Director group (see Figure 82 on page 274):
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceiversand fiber-optic cablesconnected
to transceivers emit laser light that can damage your eyes.
1. Connect the port labeled 3 on the first network module on one of the Director devices
to the corresponding port (labeled 3) on the first network module on the second
Director device.
2. Connect the port labeled 3 on the second network module on one of the Director
devices to the corresponding port (labeled 3) on the second network module on the
second Director device.
Related
Documentation
Connecting QFX3100 Director Devices to the Control Plane Network on page 275•
• Connecting a QFX3008-I Interconnect Device to the Control Plane Network on page 278
• Connecting a QFX3500 Node Device to the Control Plane Network on page 282
Connecting QFX3100 Director Devices to the Control Plane Network
A QFX3000 QFabric system control plane and management network is formed by
connecting the QFX series devices in your network to two Virtual Chassis composed of
four EX4200 switches each. QFX3100 Director devices have two 4-port Gigabit Ethernet
network modules with RJ-45 connectors. Use the network module ports to connect the
QFX3100 Director group to each Virtual Chassis (see Figure 83 on page 276).
275Copyright © 2012, Juniper Networks, Inc.
Chapter 22: Cabling the QFabric Switch