NOTE: In North America, AC power cords must not exceed 4.5 meters
(approximately 14.75 feet) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical
Code(CEC) Section4-010(3). The cords supplied with the QFX3100Director
device are in compliance.
Table 44 on page 136 lists AC power cord specifications provided for each country or
region.
Table 44: AC Power Cord Specifications for a QFX3100 Director Device
Plug StandardsElectrical SpecificationsCountry or Region
AS/NZ 3112-1993250 VAC, 10 A, 50 HzAustralia
GB2099.1 1996 and GB1002 1996
(CH1-10P)
250 VAC, 10 A, 50 HzChina
CEE (7) VII250 VAC, 10 A, 50 HzEurope (except Italy, Switzerland,
and United Kingdom)
CEI 23-16/VII250 VAC, 10 A, 50 HzItaly
JIS 8303125 VAC, 12 A, 50 Hz or 60 HzJapan
CEE 7/4250 VAC, 10A, 50 HzKorea
NEMA 5-15125 VAC, 13 A, 60 HzNorth America
SEV 1011 SEV 6534/2250 VAC, 10A, 50 HzSwitzerland
BS 1363A250 VAC, 10 A, 50 HzUnited Kingdom
Figure 53 on page 136 illustrates the plug on the power cord for some of the countries or
regions listed in Table 44 on page 136.
Figure 53: AC Plug Types
Related
Documentation
• AC Power Supply in a QFX3100 Director Device on page 30
• General Safety Guidelines and Warnings on page 161
• General Electrical Safety Guidelines and Warnings on page 191
• Prevention of Electrostatic Discharge Damage on page 192
Copyright © 2012, Juniper Networks, Inc.136
QFX3000 Hardware Documentation
To Next Page
Loading...
Need help?
General