NOTE: If you want to find the serial number on the physical device component,
you will need to remove the component from the device chassis, for which
you must have the required parts and tools available.
1.
Listing the Chassis and Component Details with the CLI on page 428
Listing the Chassis and Component Details with the CLI
To list the QFX3008-I Interconnect device and components and their serial numbers,
use the show fabric administration inventory interconnect-devices device-name CLI
command.
For information about the show fabric administration inventory interconnect-devices
command, see show fabric administration inventory interconnect-devices.
Related
Documentation
Returning a QFX3008-I Interconnect Device or Component for Repair or Replacement
on page 427
•
Packing a QFX3008-I Interconnect Device or Component for Shipping
If you are returning a QFX3008-I Interconnect device or component to Juniper Networks
for repair or replacement, pack the item as described in this topic.
Before you begin packing a QFX3008-I Interconnect device or component, ensure that
you have:
•
Taken the necessary precautions to prevent ESD damage (see “Prevention of
Electrostatic Discharge Damage” on page 192).
•
Retrieved the original shipping carton and packing materials. Contact your Juniper
Networks Technical Assistance Center (JTAC) representative if you do not have these
materials, to learn about approved packing materials. See “Contacting Customer
Support to Obtain a Return Materials Authorization for a QFX Series Device or
Component” on page 435.
Ensure that you have the following parts and tools available:
•
Antistatic bag, one for each component
•
Electrostatic discharge (ESD) grounding strap
•
Phillips (+) screwdriver, number 2
This topic describes:
1.
Packing a QFX3008-I Interconnect Device for Shipping on page 429
2.
Packing QFX3008-I Interconnect Device Components for Shipping on page 430
Copyright © 2012, Juniper Networks, Inc.428
QFX3000 Hardware Documentation
To Next Page
Loading...
Need help?
General