Juniper QFX Series User Manual

Figure 97: Installing an AC Power Supply in a QFX3008-I Interconnect
Device
g050123
Tighten
thumbscrew
Related
Documentation
AC Power Supply in a QFX3008-I Interconnect Device on page 52•
• Removing an AC Power Supply from a QFX3008-I Interconnect Device on page 323
Removing a Wiring Tray from a QFX3008-I Interconnect Device
The wiring tray in a QFX3008-I Interconnect device is a hot-insertable and hot-removable
field-replaceable unit (FRU). Two wiring trays are installed in the rear of the chassis.
Before you remove a wiring tray from the device, ensure that you understand how to
prevent ESD damage. See “Prevention of Electrostatic Discharge Damage” on page 192.
Ensure that you have the following parts and tools available to remove a wiring tray from
a QFX3008-I Interconnect device:
•
Electrostatic discharge (ESD) grounding strap
•
Phillips (+) screwdriver, number 1
•
Replacement wiring tray
CAUTION: Do not leave the wiring tray slot empty while the device is
operational. Replace the wiring tray promptly.
Copyright © 2012, Juniper Networks, Inc.326
QFX3000 Hardware Documentation

Juniper QFX Series Specifications

General

Category	Switch
Series	QFX
Form Factor	1U, 2U, and modular chassis options
Power Supply	Redundant, hot-swappable power supplies
Cooling	hot-swappable fans
Virtual Chassis	Supported on certain models
Typical Use	Data center, cloud
Operating System	Junos OS
Management	CLI
Key Features	High performance, low latency, automation
Latency	Sub-microsecond latency
Port Density	Varies by model (e.g., QFX5100: up to 48x10GbE + 6x40GbE)