Figure 113: Installing a Control Board in a QFX3008-I Interconnect Device
Related
Documentation
Control Board in a QFX3008-I Interconnect Device on page 49•
• Control Board LEDs on a QFX3008-I Interconnect Device on page 389
Taking a 16-Port QSFP+ Front Card Offline in a QFX3008-I Interconnect Device
To prevent data loss, we recommend that you take a 16-port QSFP+ front card offline
before removing it from a QFX3008-I Interconnect device.
To take the front card offline in a QFX3008-I Interconnect device:
1. Use the request chassis fpc interconnect-device name slot slot-number offline CLI
command. Enter the name of the device in which the front card you want to remove
is installed, and the number of the slot from which you are removing the front card;
the slots are numbered from 0 through 7. See “Slot Numbering for a QFX3008-I
Interconnect Device” on page 40.
2. Use the show chassis fpc CLI command to verify that the front card is offline. When
the state field in the command output shows that the card is offline, it is safe to remove
the front card. See “Removing a 16-Port QSFP+ Front Card from a QFX3008-I
Interconnect Device” on page 352.
Related
Documentation
Installing a 16-PortQSFP+ Front Card in a QFX3008-I Interconnect Device on page 353•
• 16-Port QSFP+ Front Cards in a QFX3008-I Interconnect Device on page 48
• 16-Port QSFP+ Front Card LEDs on a QFX3008-I Interconnect Device on page 391
351Copyright © 2012, Juniper Networks, Inc.
Chapter 26: Replacing QFX3008-I Components
To Next Page
Loading...
Need help?
General
