Juniper QFX Series - Compliance; Agency Approvals for the QFX Series

NOTE: The QFX-SFP-1GE-T transceiver is not supported on the QFX3100
Director device.For 1000BASE-Tconnections to the QFX3100Director device,
ensure that you have installed RJ-45 network modules.
NOTE: Use only transceivers purchased from Juniper Networks for your QFX
Series device.
Table 38 on page 125 describes interface support for Gigabit Ethernet SFP transceivers.
Table 38: Interface Support for Gigabit Ethernet SFP Transceivers for Control Plane Connections
Specifications
Ethernet
Standard
QFX-SFP-1GE-T
NOTE: The QFX-SFP-1GE-Ttransceiver is not supportedon the QFX3100
Director device. For 1000BASE-T connections to the QFX3100 Director
device, ensure that you have installed RJ-45 network modules.
Model number1000BASE-T
1000 MbpsRate
RJ-45Connector type
CopperFiber count
–Transmitter wavelength
–Minimum launch power
–Maximum launch power
–Minimum receiver sensitivity
–Maximum input power
Not availableDOM support
Junos OS for QFX Series, Release 11.3 or laterSoftware required
CopperFiber type
–Core/cladding size
–Modal bandwidth
100 m (328 ft)Distance
125Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Port and Interface Specifications