Mindray BeneVision N22 - Displaying QT Numerics and Segments; QT View

BeneVision N22/N19 Patient Monitor Operator’s Manual 10 - 23
10.8.3 Displaying QT Numerics and Segments
To display QT numerics and Segments, follow this procedure:
1. Access
Tile Layout by either of the following ways:
◆ Select the Screen Setup quick key → select the Tile Layout tab.
◆ Select Main Menu quick key → from the Display column select Tile Layout.
2. Click the parameter numeric area where you want to display the QT numerics, and then select
ECG → QT/
QTc
.
The following picture shows the QT numeric area. Your monitor screen may look slightly different:
NOTE
• The display of the QT numeric area differs as related settings change.
10.8.4 QT View
The QT view shows a piece of ECG waveform and QT-related numerics of each ECG lead.
The following picture shows the QT view.
(1) QTc alarm limit (if QTc alarm is off, the alarm off symbol is displayed)
(2) Parameter label (3) QTc value
(4) QTc value (the difference between the current and baseline QTc values)
(5) QT value
(4)
(2)
(1
)
(5)
(3)