BeneVision N22/N19 Patient Monitor Operator’s Manual 8 - 3
8.3 Supported Devices
• BeneLink module may support more devices than those listed in the above table. Contact your
service personnel for the most recent information on the supported devices.
8.4 Differences in Displayed Values
In certain cases, there may be differences between the numerics displayed on the monitor and those on external
devices. The table below lists some situations and possible reasons.
Device Category Model
Anesthesia machine Draeger Fabius GS/Fabius Tiro/Fabius Plus/Primus
GE Aestiva 7900/Aestiva 7100/Avance Carestation/Aisys
Mindray A3/A5/A7
Mindray Wato 20/25/30/35/50/55/60/65
Ventilator Carefusion Vela
Draeger Evita 2
Draeger Evita 4/ Evita2 dura/Evita XL
GE Engström Carestation (Neo), GE Engström Carestation (Pro)
Hamilton G5/C1/C2 /C3/Galileo
Maquet Servo-i/Servo-s
Mindray Syno Vent E3/E5/300
Mindray SV300
Newport E360
Philips Respironics V60
Puritan Bennett 840
Situation Possible Reasons
Some parameter values are displayed as invalid
values on the monitor.
The patient monitor and the external device may have different
parameter configuration or displaying range of values. If the
patient monitor displays a parameter not configured in the
external device, or a parameter value from the external device
exceeds the displaying range of the monitor, corresponding
parameter value is displayed on the monitor as an invalid value.
The monitor and external device display parameter
values with different numbers of places of decimals.
The monitor displays parameter values from the external device
based on the monitor displaying rules. Same parameter value is
displayed differently when the monitor and the external device
adopts different numbers of places of decimals.
Non-continuously measured values and
continuously measured values have the same
displaying mode in the patient monitor.
For non-continuously measured values, the monitor displays the
latest measured values until a new measurement is taken by the
external device.
Parameter values displayed on the patient monitor
and those displayed in the external device are
slightly different.
Some parameter values are converted to different units when
transmitted to the monitor for calculations. Sometimes, values
from the external device may be advanced or delayed before
transmission to the patient monitor.