Mindray BeneVision N22 - Changing Tcgas Settings; Activating the Tcgas Alarm Sound; Changing the Tcpco2;Tcpo2 Unit

25 - 4 BeneVision N22/N19 Patient Monitor Operator’s Manual
25.6 Changing tcGas Settings
25.6.1 Activating the tcGas Alarm Sound
To activate the tcGas alarm sound, follow this procedure:
1. Select the tcGas numeric area to enter the
+tcGas Setup menu.
2. Set
Alarm Sound to On.
After the tcGas alarm sound is activated, the patient monitor gives sound prompts for the alarms of the TCM
monitor.
25.6.2 Changing the tcpCO2/tcpO2 Unit
To change the tcpCO2/tcpO2 unit, follow this procedure:
1. Select the
Main Menu quick key → turn to the third page → from the System column select Maintenance
→ input the required password → select Ok.
2. Select the
Unit tab.
3. Set
tcpCO2/tcpO2 Unit.