16 - 2 BeneVision N22/N19 Patient Monitor Operator’s Manual
16.1 IBP Introduction
You can measure invasive blood pressure (IBP) using the MPM, or the IBP module. This patient monitor can
monitor up to 10 invasive blood pressures.
IBP monitoring is intended for adult, pediatric, and neonatal patients. PAWP monitoring is only intended for
adult and pediatric patients.
• If your monitor configures the PiCCO module, you can also measure IBP with the PiCCO module. For
more information, see 21 Monitoring Continuous Cardiac Output (CCO).
16.2 IBP Safety Information
• Use only pressure transducers specified in this manual. Never reuse disposable pressure
transducers.
• Make sure that no part of the patient connections touches any electrically conductive material
including earth./Make sure that the applied parts never contact other conductive parts.
• To reduce the hazard of burns during high-frequency surgical procedure, ensure that the monitor’s
cables and transducers never come into contact with the high-frequency surgical units.
• When using accessories, their operating temperature should be taken into consideration. For more
information, see instructions for use of accessories.
• All invasive procedures involve risks to the patient. Use aseptic technique. Follow catheter
manufacturer's instructions.
• Mechanical shock to the invasive blood pressure transducer may cause severe shifts in zero balance
and calibration, and cause erroneous readings.
(1) Zero IBP hard key (2) IBP menu hard key (3) IBP cable connector
To Next Page
Loading...
Need help?
General
