BeneVision N22/N19 Patient Monitor Operator’s Manual 6 - 7
6.7.2 Setting the Wired Network
To set the wired network, follow this procedure:
1. Select the Main Menu quick key → turn to the third page → from the System column select Maintenance
→ input the required password → select Ok.
2. Select the Network tab→LAN1 tab.
3. Select how to get the IP address.
â—† Obtain IP Address Automatically: the monitor automatically gets the IP address.
â—† Use the following Address: you need to input the IP address, Subnet mask, and Gateway.
6.7.3 Setting the Wireless Network
To set the wireless network, follow this procedure:
1. Select the Main Menu quick key → turn to the third page → from the System column select Maintenance
→ input the required password → select Ok.
2. Select the Network Setup tab→WLAN.
3. Input SSID, Security, and Password.
4. Select the More WLAN to select how to get the IP address.
â—† Auto Get IP Address: the monitor automatically gets the IP address.
â—† Use the following Address: you need to input the IP address, Subnet mask, and Gateway.
The monitor supports the following security methods: WEP OFF, WEP ON, WPA PSK, WPA TKIP, WPA2 PSK, WPA2
AES, CCKM TKIP, CCKM AES, WPA PSK AES, WPA AES.
Selecting the security method as desired. You may need to set more parameters for some security methods.
6.7.4 Selecting WLAN Band and Channels
The monitor supports 2.4 G and 5 G WLAN. To select WLAN band rate and channels, follow this procedure:
1. Select the Main Menu quick key → turn to the third page → from the System column select Maintenance
→ input the required password → select Ok.
2. Select the Network Setup tab→WLAN tab.
3. Select WLAN Setup from the bottom left corner of the menu.
4. Set Monitor to Auto, 5G, or 2.4G according to the band you are using. The default is Auto, which means
the monitor can automatically identify the WLAN band.
5. Select Auth Server Type to set the type of authentication server.
6. Select BG Channel to set the type of B and G channels.
7. Select A Channel to set the type of A channel.
6.7.5 Managing Certifications
You can delete certifications from the monitor, or import certifications from the USB memory. To do so, follow
this procedure:
1. Select the Main Menu quick key → turn to the third page → from the System column select Maintenance
→ input the required password → select Ok.
2. Select the Network Setup tab→WLAN tab.
3. Select Certification Management from the bottom left corner of the menu.
â—† From the Local tab, select certifications you want to delete from the monitor, and then select Delete.
To Next Page
Loading...
Need help?
General
