BeneVision N22/N19 Patient Monitor Operator’s Manual 1 - 3
1.1.2 Cautions
• Use only parts and accessories specified in this manual.
• Ensure that the equipment is supplied with continuous electric power during work. Sudden power
failure may cause data loss.
• Magnetic and electrical fields are capable of interfering with the proper performance of the
equipment. For this reason make sure that all external devices operated in the vicinity of the
equipment comply with the relevant EMC requirements. Mobile phone, X-ray equipment or MRI
devices are a possible source of interference as they may emit higher levels of electromagnetic
radiation.
• Always install or carry the equipment properly to avoid damage caused by drop, impact, strong
vibration or other mechanical force.
• Dry the equipment immediately in case of rain or water spray.
• Dispose of the package material as per the applicable waste control regulations. Keep it out of
children’s reach.
• At the end of its service life, the equipment, as well as its accessories, must be disposed of in
compliance with the guidelines regulating the disposal of such products. If you have any questions
concerning disposal of the equipment, please contact us.
1.1.3 Notes
• Put the equipment in a location where you can easily view and operate the equipment.
• The equipment use a mains plug as isolation means to the mains power. Do not locate the
equipment in a place difficult to operate the mains plug.
• The typical operator's position is in front of the monitor.
• The software was developed in compliance with IEC60601-1-4. The possibility of hazards arising
from software errors is minimized.
• This manual describes all features and options. Your equipment may not have all of them.
• Keep this manual in the vicinity of the equipment so that it can be obtained conveniently when
needed.
1.2 Equipment Symbols
Symbol Description Symbol Description
General warning sign Refer to instruction manual/booklet
Serial number Catalogue number
Date of manufacture Manufacturer
USB connector Protected against vertically falling water
drops per IEC 60529
To Next Page
Loading...
