BeneVision N22/N19 Patient Monitor Operator’s Manual 32 - 7
32.6 Changing Hemodynamic Parameter Settings
32.6.1 Setting Hemodynamic Parameter Ranges
To set the ranges of hemodynamic parameters, follow this procedure:
1. Select the numeric area of
CCO, ScvO2, or SvO2.
2. Select
Hemodynamics.
3. Select the
Setup tab.
4. Set the normal ranges of the hemodynamic parameters.
32.6.2 Restoring Default Values
To restore the default values, follow this procedure:
1. Select the numeric area of
CCO, ScvO2, or SvO2.
2. Select
Hemodynamics.
3. Select the
Setup tab.
4. Select the
Default button.
• Selecting Default restores all the parameter ranges to defaults.
32.6.3 Setting the Spider Vision Pattern
To set the spider vision pattern, follow this procedure:
1. Select the numeric area of
CCO, ScvO2, or SvO2.
2. Select
Hemodynamics.
3. Select the
Setup tab.
4. Select the
SpiderVision tab.
5. Make the following settings:
â—† Select the number of spider legs (three to seven).
â—† Select the parameter to be displayed.
â—† Select Save, Save As or Delete to save, create or delete a pattern.
• You cannot delete the default pattern orthe pattern that is in use.
To Next Page
Loading...
Need help?
General
