29 - 4 BeneVision N22/N19 Patient Monitor Operator’s Manual
29.6 Changing NMT Settings
29.6.1 Activating the NMT Alarm Sound
To activate the NMT alarm sound, follow this procedure:
1. Select the NMT numeric area to access the [+NMT Setup] menu.
2. Set the
Alarm Sound to On.
After the NMT alarm sound is activated, the monitor gives sound prompts for the alarms of the TOF-Watch SX
monitor.
29.6.2 Viewing the Measurement Setup
To view the NMT measurement setup, follow this procedure:
1. Select the NMT numeric area to access the [+NMT Setup] menu.
2. View the settings as follows:
â—† Stimulation Current
â—† Stimulation Charge
â—† Pulse Width
â—† TOFs Interval
â—† Transducer Sensitivity
To Next Page
Loading...
Need help?
General
