19 - 2 BeneVision N22/N19 Patient Monitor Operator’s Manual
19.1 CCO/SvO
2
Introduction
The Edwards Vigilance II monitor and Vigileo monitor measure continuous cardiac output (CCO), mixed venous
oxygen saturation (SvO
2
), central venous oxygen saturation (ScvO
2
) etc. The Vigilance II monitor and Vigileo
monitor also calculates hemodynamic and oxygenation parameters. This monitor can be connected to the
Vigilance II monitor/Vigileo monitor and can display, store, and review the measured and calculated parameter
values from the Vigilance II monitor/Vigileo monitor. This monitor can also give alarms of these measured
parameters. You must set alarm on/off, alarm limits, alarm priority, and alarm record separately on this monitor.
The alarm is On by default.
The Vigilance II monitor and Vigileo monitor are manufactured by Edwards Lifesciences. This company provides
the technology of measuring and calculating the relevant parameters. We only provide the connection between
this monitor and Vigilance II monitor/Vigileo monitor. If you have any doubts about the operation and
maintenance of the Vigilance II monitor/Vigileo monitor, please read the Vigilance II monitor and Vigileo monitor
operator’s manuals or contact Edwards Lifesciences (www.edwards.com) directly.
The CCO/SvO
2
module is only intended for adult and pediatric patients.
19.2 CCO/SvO
2
Safety Information
• Because the alarm limits of the relevant measured parameters can be set on this monitor, the alarms
of these parameters may be different from those on the Vigilance II/Vigileo monitor. Please pay
special attention to the alarms on the Vigilance II/Vigileo monitor.
• The CCO/SvO
2
module is not intended for neonatal patients.
• Fully observe the Vigilance II monitor and Vigileo monitor operator’s manuals to configure settings
and to connect the monitor to the patient.
(1) CCO/SvO2 menu hard key (2) Calibration key
(3) Module status indicator (4) CCO/SvO
2
cable connector
To Next Page
Loading...
Need help?
General
