Inspecting with Color Data Inspection Item
296
FQ2-S/CH User’s Manual
Step 3 Adjusting Judgment Parameters
[Inspect] − [Inspection] − [Add item.] − [Color Data] − [Settings] Tab Page
1 Press [Judgement].
2 Press the parameters and set the range that is to be
judged as OK.
The measured value is displayed beside the parameter
name. Continuous measurements will be performed for
the images that are displayed.
You can change the parameters for judgment conditions on the Display Settings Display. Press [ ] − [Display set-
ting] on the right of the display to switch to the Display Settings Display.
3 Press [OK] to enter the value.
Blue for OK. Red for NG.
Lower limit
Upper limit
To Next Page
Loading...
