Omron FQ2-S/CH Series

Setting the Retry Function
426
FQ2-S/CH User’s Manual
Reading order of the Sort order
The scanning procedure when the sort order is set to auto is shown below.
1st : The last Scene which was scanned successfully.
2nd and following: Scene order by most successful scans
• In the Default state, the order is the order of the scene numbers.
• If the power is interrupted or the sensor is restarted, the success counts are initialized when adjust mode is entered.
For the timing chart, refer to the following manual:
FQ2-S/CH Series User's Manual for Communications Settings (Cat. No. Z338)
Scan criteria for last successful Scan.
Scene 1
Success count: 25
Scene 1
Success count: 25
Scene 2
Success count: 1
Scene 2
Success count: 1
Scene 3
Success count: 50
Scene 3
Success count: 50
Scene 4
Success count: 15
Scene 4
Success count: 15
Scene 5
Success count: 9
Scene 5
Success count: 9
Note