Protocol analysisMXO 4 Series
372User Manual 1335.5337.02 ─ 07
Threshold
Sets the threshold for the SIC and Fast channels. Enter the value directly in the fields.
Additional to the threshold, you can also set a hysteresis.
Remote command:
SBUS<sb>:CAN:FAST:HYSTeresis on page 765
SBUS<sb>:CAN:FAST:THReshold on page 765
SBUS<sb>:CAN:SIC:HYSTeresis on page 764
SBUS<sb>:CAN:SIC:THReshold on page 765
Show threshold lines
If enabled, the threshold lines are displayed in the diagram.
The label of the threshold line is set according to the signal that it is referring to, see
also Show threshold lines.
Remote command:
SBUS<m>:THReshold on page 705
13.5.1.3 Display settings
For details about the display settings, see Chapter 13.1.4, "Display", on page 315.
CAN (option R&S
MXO4-K520)
To Next Page
Loading...
