Rohde & Schwarz MXO 4 Series - Page 678

Remote control commandsMXO 4 Series
678User Manual 1335.5337.02 ─ 07
Suffix:
<m>
.
1...3, index of the power analysis measurement
Parameters:
<CurrentSource> C1 | C2 | C3 | C4
Usage: Asynchronous command
Manual operation: See "Current" on page 277
POWer<m>:QUALity:SOURce[:VOLTage] <VoltageSource>
Sets the channel for the voltage source input of the power quality analysis.
Suffix:
<m>
.
1...3, index of the power analysis measurement
Parameters:
<VoltageSource> C1 | C2 | C3 | C4
Usage: Asynchronous command
Manual operation: See "Voltage" on page 276
POWer<m>:QUALity:FREQuency[:VALue] <FundamFreq>
Sets the input frequency of the source signal in Hz.
Suffix:
<m>
.
1...3, index of the power analysis measurement
Parameters:
<FundamFreq> F50 | F60 | F400 | USER | AUTO
*RST: F50
Usage: Asynchronous command
Manual operation: See "Fund. Freq" on page 277
POWer<m>:QUALity:FREQuency:USER <FundamentalFreq>
Sets the user-defined frequency, if POWer<m>:QUALity:FREQuency[:VALue]
on page 678 is set to USER.
Suffix:
<m>
.
1...3, index of the power analysis measurement
Parameters:
<FundamentalFreq> Range: 10 to 1000000
Increment: 1
*RST: 50
Default unit: Hz
Usage: Asynchronous command
Manual operation: See "Fund. Freq" on page 277
Applications