Rohde & Schwarz RTE Series - Page 1478

Remote control commands
R&S
®
RTE
1478User Manual 1326.1032.02 ─ 20
BUS<m>:UART:BITRate............................................................................................... 1480
BUS<m>:UART:BAUDrate............................................................................................ 1480
BUS<m>:UART:PARity................................................................................................. 1480
BUS<m>:UART:POLarity.............................................................................................. 1481
BUS<m>:UART:SBIT....................................................................................................1481
BUS<m>:UART:SSIZe..................................................................................................1481
BUS<m>:UART:PACKets..............................................................................................1481
BUS<m>:UART:TOUT.................................................................................................. 1482
BUS<m>:UART:EWORd............................................................................................... 1482
BUS<m>:UART:RX:SOURce <RxSource>
Selects the input channel for the receiver signal.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<RxSource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 |
M5 | M6 | M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 |
D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
Digital and analog channels cannot be used at the same time for
RX and TX lines.
See Chapter 18.4.2, "Waveform parameter", on page 1074
*RST: None
Usage: Asynchronous command
BUS<m>:UART:TX:SOURce <TxSource>
Selects the input channel for the transmitter signal.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<TxSource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 |
M5 | M6 | M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 |
D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
Digital and analog channels cannot be used at the same time for
RX and TX lines.
See Chapter 18.4.2, "Waveform parameter", on page 1074
*RST: C1W1
Usage: Asynchronous command
BUS<m>:UART:RX:THReshold <RxThreshold>
Sets a user-defined threshold value for the Rx line.
Protocols