EasyManuals Logo

ST STM32L4 5 Series User Manual

ST STM32L4 5 Series
1830 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #299 background imageLoading...
Page #299 background image
DocID024597 Rev 5 299/1830
RM0351 General-purpose I/Os (GPIO)
308
8.3.13 Using the HSE or LSE oscillator pins as GPIOs
When the HSE or LSE oscillator is switched OFF (default state after reset), the related
oscillator pins can be used as normal GPIOs.
When the HSE or LSE oscillator is switched ON (by setting the HSEON or LSEON bit in the
RCC_CSR register) the oscillator takes control of its associated pins and the GPIO
configuration of these pins has no effect.
When the oscillator is configured in a user external clock mode, only the pin is reserved for
clock input and the OSC_OUT or OSC32_OUT pin can still be used as normal GPIO.
8.3.14 Using the GPIO pins in the RTC supply domain
The PC13/PC14/PC15 GPIO functionality is lost when the core supply domain is powered
off (when the device enters Standby mode). In this case, if their GPIO configuration is not
bypassed by the RTC configuration, these pins are set in an analog input mode.
For details about I/O control by the RTC, refer to Section 38.3: RTC functional description
on page 1188.
8.3.15 Using PH3 as GPIO (only for STM32L496xx/4A6xx devices)
PH3 may be used as boot pin (BOOT0) or as a GPIO. Depending on the nSWBOOT0 bit in
the user option byte, it switches from the input mode to the analog input mode:
After the option byte loading phase if nSWBOOT0 = 1.
After reset if nSWBOOT0 = 0.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ST STM32L4 5 Series and is the answer not in the manual?

ST STM32L4 5 Series Specifications

General IconGeneral
BrandST
ModelSTM32L4 5 Series
CategoryMicrocontrollers
LanguageEnglish

Related product manuals