RESULT INTERPRETATION/REPORTS
Sysmex SF-3000 Operator's Manual -- Revised February 1997 4-1
1. INTRODUCTION
The SF-3000 is used to analyze and screen whole blood samples, and to store and
reproduce the sample results. This chapter explains the screen displays, output and
processing of analysis results in the Stored Data program.
This chapter consists of the following major sections:
INTERPRETIVE MESSAGES
A significant feature of the SF-3000 is the use of Interpretive (IP) messages. This
section describes the various messages employed by the system, their meaning,
and the conditions in which they appear.
ANALYSIS RESULT DISPLAYS
In the Stored Data program, analysis results are displayed in list format and graphic
format. Here it is explained how to select these formats, the items displayed in
each format, and the meaning of the items displayed.
PROCESSING OF ANALYSIS DATA
In the Stored Data program, various manipulations of displayed data are possible -
changing the type of data displayed or the order it is displayed in, changing
analysis data, etc. How to manipulate data using this program is explained.
AUTO OUTPUT
Stored sample data can be printed out automatically by a Data Printer or Graphic
Printer, or transmitted automatically to a Host Computer.
STORED DATA OUTPUT
Stored marked sample data and date-specified data can be output to Data Printer,
Graphic Printer and/or Host Computer. Also these data can be output to a floppy
disk as a back up . This section explains the procedures for these outputs.
Sysmex SF-3000 Operator's Manual -- Revised September 1995
To Next Page
Loading...
Need help?
General
