SYSTEM SETUP
Sysmex SF-3000 Operator's Manual -- Revised September 1995 11-49
6.5 Normal Range Display
Use this program to set whether or not normal range displays (Normograms) will appear
on the graphic display screens, graphic printouts and hard-copy printouts.
To set normal range display:
(1) Press [Normal Range] key in the General Set Up submenu. The Input Password
window will appear.
(2) Enter the password and press [ENTER] key.
The normal range display setting screen containing the current setting will appear.
(3) If "With Normal Range" is selected, a "√" mark is displayed on the screen. To
disable the setting (to select "Without Normal Range"), press the key marked "√"
again.
NOTE: The factory setting is "With Normal Range" (marked with "√").
< NORMAL RANGE >
Normal Range
Quit
Date/
Time
Units
Normal
Range
Date
Format
Timer
Mode
Password More Return
DP:1234567890123
Sysmex
XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
√
Figure 11-41: Normal Range Setting Window
(4) Press [Quit] key to exit the program. The confirmation message will appear. Press
the appropriate key [Continue], [Set] or [Cancel].
Continue : To return to Normal Range setting screen so that setting can be
continued.
Set : To save the new settings. Program ends.
Cancel : To cancel the new settings. Program ends.
To Next Page
Loading...
