SYSMEX SF-3000 - Chapter 5 Maintenance & Supplies

Revised September 1995
CHAPTER 5 MAINTENANCE & SUPPLIES
1. INTRODUCTION .............................................................. 5-1
2. SF-3000 MAINTENANCE CHECK LIST.................................. 5-3
3. DAILY MAINTENANCE...................................................... 5-4
3.1 Clean Detector Chamber and Manometer (Shutdown)............... 5-4
3.2 Remove Fluid from Pneumatic Unit Trap Chamber ................. 5-6
4. WEEKLY MAINTENANCE .................................................. 5-7
4.1 Clean SRV Tray.......................................................... 5-7
4.2 Execute Clean WBC Detector Sequence............................... 5-9
5. MONTHLY MAINTENANCE...............................................5-14
5.1 Clean Orifice.............................................................5-14
5.2 Execute Clean Waste Chamber Sequence ............................5-16
5.3 Clean Sample Rotor Valve (SRV).....................................5-21
6. YEARLY MAINTENANCE..................................................5-26
6.1 Visual Inspection for Laser Safety ....................................5-26
7. AS NEEDED MAINTENANCE .............................................5-29
7.1 Clean Manual Rinse Mechanism ......................................5-29
7.2 Execute RBC Aperture Clog Removal Sequence....................5-31
7.3 Execute Clean RBC Transducer Sequence...........................5-33
7.4 Clean RBC Detector Aperture .........................................5-38
7.5 Execute WBC Flow Cell Air Bubbles Removal Sequence.........5-41
7.6 Execute Replace Sheath Flow Reagent Sequence ...................5-43
7.7 Replace Waste Container (if used) ....................................5-45
8. REPLACEMENTS.............................................................5-46
8.1 Replace Reagent.........................................................5-46
8.1.1 Reagent Log .....................................................5-50
8.2 Replace the Piercer (Auto Sampler Unit).............................5-51
8.3 Replace the Piercer (Manual CP Unit)................................5-58
8.4 Replace the Hand Clipper (Auto Sampler Unit) .....................5-62
8.5 Replace the Rubber Plate No. 39 (Auto Sampler Unit).............5-63
8.6 Replace the Anti-Shock Rubber No. 49 (Auto Sampler Unit).....5-64
8.7 Replace the Fuses .......................................................5-65
8.8 Replace the Belt No. 6..................................................5-67
9. RESET THE COUNTER .....................................................5-69
10. FORMAT FD ...................................................................5-72
11. SUPPLIES AND REPLACEMENT PARTS LISTING ..................5-74