RESULT INTERPRETATION/REPORTS
4-26 Sysmex SF-3000 Operator's Manual -- Revised September 1995
7. SELECT DISPLAY
This program will allow the operator to select the type of samples to be displayed in the
List Display program. This program can only select the samples that are stored in the
memory.
To execute Select Display:
(1) Press the [Stored Data] keypad in the Root Menu. The List Display with second
menu keys will appear.
(2) Press the [Select Display] keypad in the second menu. The Select Display
submenu window shown in Figure 4-12 appears.
Search
Select
Display
Edit
Info.
Sort
Graphic Valid.
More
XM
Cancel
Select Display / Flag
Stored Data
DATE
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
12/31 1
DP:1234567890123
Sysmex
Ready
Manual Mode Next No.1234567890123
Sampler
HC GP DP SU
0 / 500 (500)
RACK TIME SEQ.
SAMPLE NO.
= ALL SAMPLES =
TUBE POS OUT MARKERROR STOP
Negative
Diff.POS.
Morph.POS.
Count POS.
O K
Error
Return
Prev
Mark
v
v
v
v
v
v
v
v
v
v
v
v
v
v
v
v
v
v
Next
↓
↑
←
→
Figure 4-12: Select Display Submenus
(3) Press the desired keypad to specify the data that you want to appear on the List
Display.
Refer to the following sections for the procedures.
NOTE: The List Display continues according to the selections made with this
program until new settings are done. However, when the power is
turned OFF, the list defaults to the original specifications of "All
Samples".
To Next Page
Loading...
Need help?
General
