SYSMEX SF-3000 - Password

SYSTEM SETUP
Sysmex SF-3000 Operator's Manual -- Revised December 1995 11-47
6.3 Password
Use this program to change the password to be entered for log in.
To set the password:
(1) Press [Password] key in the General Set Up submenu. The Input Password
window will appear.
(2) Enter the current password and press [ENTER] key.
The Password setting screen and numeric keys will appear.
(3) Input the new password and press [ENTER].
The password can consist of up to 12 digits. A beep will alert the operator if an
incorrect value is entered.
CAUTION: When the password is set to zero (0), the Input Password
window will not appear. This will allow the operator to access
any program without entering the password.
Date/
Time
Units
Normal
Range
Date
Format
Timer
Mode
Password More Return
DP:1234567890123
Sysmex
XM HC GP DP SU
Ready Manual Mode Next No.1234567890123
Sampler
*****
PASSWORD
Password
ENTER
C
78
9
456
12 3
0
*****
QUIT
•
Figure 11-39: Password Setting Window
(4) Press [QUIT] key to exit the program. The confirmation message will appear.
Press the appropriate key [Continue], [Set] or [Cancel].
Continue : To return to Password setting screen so that setting can be
continued.
Set : To save the new settings. Program ends.
Cancel : To cancel the new settings. Program ends.