TROUBLESHOOTING
8-48 Sysmex SF-3000 Operator's Manual -- Revised September 1995
Stored Data Full
Phenomena Number of samples stored has exceeded memory capacity.
Analysis cannot continue until the error is resolved.
Probable Cause Number of samples stored has exceeded 1000.
Corrective Action 1) Delete the stored data. Refer to
Chapter 4, Section 12: Delete Stored
Data
until the number of stored data becomes less than 1000.
2) Set the Auto Erase mode setting to "FIFO". Refer to
Chapter 11, Section
2.3: Auto Erase
.
12. ID Errors
ID Read Error
Rack ID Read Error
Phenomena ID reader cannot read the ID bar code label correctly attached on a collection
tube or a sample rack.
When the sample being processed is completed, the system returns to
Ready.
If the system is set to be stopped by this error, the system will be STAT ready
for the sample analysis in manual or capillary mode.
If the system is set to continue analysis when this error occurs, the system
will process the next sample.
Probable Cause 1) The ID bar code label is stained with blood or is dirty.
2) The position of ID bar code label is incorrect.
3) The ID bar code label is out of specification.
Corrective Action 1) Check that the ID bar code label is clear and smooth and is attached to
the tube or rack correctly. Refer to
Appendix C: Technical Information
for
the ID bar code label specification.
2) Correct the sample ID number, if necessary.
3) Reset the rack and press [Sampler], then [Start] key to start analysis.
4) If the error persists, contact Sysmex service representative.
To Next Page
Loading...
Need help?
General
