SYSMEX SF-3000 - Date Format

SYSTEM SETUP
Sysmex SF-3000 Operator's Manual -- Revised September 1995 11-51
6.6 Date Format
Use this program to set the date format for the display and output of date.
There are 3 formats: "yymmdd", "mmddyy" or "ddmmyy".
NOTE: The date format for the DP printout is set in the DP Setting program.
Refer to Section 5.3 DP Setting in this chapter.
To set date format:
(1) Press [Date Format] key in the General Set Up submenu.
The Date Format setting screen will appear, containing the current date format
setting.
(2) Press the appropriate key [yymmdd], [mmddyy] or [ddmmyy]. The selected
format will be backlit in light-blue.
(The factory setting is "mmddyy".)
< DATE FORMAT >
Date Format yymmdd ddmmyymmddyy
Quit
Date/
Time
Units
Normal
Range
Date
Format
Timer
Mode
Password More Return
DP:1234567890123
Sysmex
XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
Figure 11-43: Date Format Setting Screen
(3) Press [Quit] key to exit the program. The confirmation message will appear. Press
the appropriate key [Continue], [Set] or [Cancel].
Continue : To return to Date Format setting screen so that setting can be
continued.
Set : To save the new settings. Program ends.
Cancel : To cancel the new settings. Program ends.