SYSMEX SF-3000 - Restarting the Pneumatic Unit; Timer Mode

SAMPLE PROCESSING
Sysmex SF-3000 Operator's Manual -- Revised October 1995 2-51
6. TIMER MODE
When timer mode is used, the Pneumatic Unit power automatically turns OFF if the Main
Unit does not detect any operation of the Start Switch or the keys on the LCD to cycle the
instrument within a preset amount of time. "Not Ready", "PU Off" and "PRESS
START SWITCH" messages are displayed in the top lines of LCD. To set, see Chapter
11: System Setup.
6.1 Restarting the Pneumatic Unit
To restart the Pneumatic Unit, press the Start Switch.
Start Switch
Figure 2-42: Press the Start Switch
CAUTION: If the Main Unit is not in Ready status, the Timer Mode does not
function and the Pneumatic Unit power will not turn OFF.