TECHNICAL INFORMATION, Text Format
Sysmex SF-3000 Operator's Manual -- Revised September 1995 C-15
2.4 Order Information Data Format
(a) Text Distinction Code I is "S".
(b) Information Status indicates if the order information has been registered.
"0": Order information has not been registered.
"1": Order information has been registered.
"2": Order is for the Quality Control purpose.
(c) Date Ordered indicates the date of order in the format of "yyyymmdd" in the
Christian Era (A.D.), where "yyyy" is the year, "mm" is the month and "dd" is the
day. Zero suppression is not performed.
(d) Sample ID No. consists of 13 digits including a hyphen "–" (2D in hexadecimal
code). Zero suppression is not performed. The sample ID No. is assigned for the
sample placed in the Rack at the Tube Position No. when the batch inquiry is
performed using the Rack No. and Tube Position No. When the sample is the
Quality Control material, either of the following two assignment methods can be
used: "000000000QCxx" where xx represents the QC file No. 01 through 12, or
"00QC-xxxxxxxx" where xxxxxxxx represents the Lot No. of the SF-CHECK.
(e) Rack No. is a 4-digit number assigned to a rack in a batch analysis. Zero
suppression is not performed. This becomes identical to the Inquiry Data Format
when the batch inquiry is performed using the Rack No. and Tube Position No.
(f) Tube Position No. is the position number in which the sample is placed within a
rack. Zero suppression is not performed. This becomes identical to the Inquiry
Data Format when the batch inquiry is performed using the Rack No. and Tube
Position No.
(g) Inquiry Mode
"1": (Not Used)
"2": Batch Inquiry, using the Rack No. and Tube Position No.
(h) Order Information for each Parameter
"0": Do not analyze
"1": Analyze
To Next Page
Loading...
Need help?
General
