SAMPLE PROCESSING
Sysmex SF-3000 Operator's Manual -- Revised December 1995 2-13
3.3 QC Analysis: Manual Closed Mode
QC analyses can be performed in Manual Closed mode if the sampler unit is installed and
SF CHECK is used. Follow the procedure below to execute quality control analyses in
Closed mode.
(1) Make sure that the READY LED is lit.
(2) Press the Next No. keypad in the top line of the LCD. The Sample No. Setting
screen will appear.
(3) The selected analysis mode is backlit in light-blue. Press [Closed Mode] to select
Closed mode, if needed.
Sysmex
DP:1234567890123
XM HC GP DP SU
Ready
Closed Mode Next No.1234567890123
Sampler
Closed Sample Number
CANCEL
ENTER
C
3
9
6
0
1
7
4
2
8
5
Ð
Q C
1234567890123
Analysis Mode
Manual Mode
Capillary Mode
Closed Mode
Figure 2-7: Sample No. Setting Screen (Closed Mode)
(4) Press [QC] key, then specify the file No. using the numerical keypads.
For example to specify the QC file No. 3, press the [QC] and the [3] keypad.
NOTE: • When SF CHECK is used, files 1 through 12 can be designated.
• The QC file No. is displayed in two digits. For instance when
pressing [QC] and [3], the file No. will be displayed as "QC03".
• Use "QC" - "Target/Limit" - "Lot Info." program to verify that the control
lot number, expiration date, analysis mode (Closed) and necessary
information are set for the specified QC file. Refer to
Chapter 6,
Section 6.6: Lot Information
for the procedure.
(5) Press the [ENTER] key. The QC file No. is specified and the QC Data Display will
appear as shown in Figure 2-8.
To Next Page
Loading...
Need help?
General
