SYSMEX SF-3000 - ID Read Status; POS to NEG

RESULT INTERPRETATION/REPORTS, Edit Sample Info.
4-48 Sysmex SF-3000 Operator's Manual -- Revised September 1995
10.2 ID Read Status
Use this program to change the ID Read notation of a sample that was read by the ID
reader or entered by the operator.
(1) Press [ID Read Status] key in the Edit Sample Info. window. "I" is placed on the
right of the ID number. If the sample already has an "I" next to the ID number, it is
removed. The display returns to the List Display.
(2) Press [Cancel] to stop the program without changing the ID Read Status, and to
return to the List Display.
10.3 POS to NEG
Use this program to change the POSITIVE status of a stored sample data to the
NEGATIVE.
NOTE: Data judged NEGATIVE cannot be changed to POSITIVE.
(1) Press [POS. to NEG.] key in the Edit Info. window. The confirmation message
window appears.
CancelO K
Will be modified POS. to NEG.
Figure 4-36: POS to NEG Confirmation Window
CAUTION: POS data changed to NEG cannot be changed back to POS.
Carefully think about your action before pressing [OK].
(2) Press [Cancel] to stop the program without changing the status, and to return to the
List Display.
(3) Press [OK] to execute POS to NEG and return to the List Display. "Mod" is
displayed in POS column in List Display (P1). The flag item numbers in List
Display (P6) disappear. On the graphic display, "Modified" is displayed under the
NEGATIVE status indicator of the sample.