WORK LIST
Sysmex SF-3000 Operator's Manual -- Revised July 1996 3-1
1. INTRODUCTION
The SF-3000 registers ordering analysis information which enables the user to specify
the samples to be analyzed.
Order information on 50 samples can be input by LCD touch panel or by transmission
from the host computer. In addition, they can be registered by downloading from a
floppy disk. This chapter describes registering and processing of analysis information.
Order information includes the followings:
• Rack No.
• Tube Position
• Sample No.
• Analysis Order
NOTE: The order information is applicable for Auto Mode analysis only.
NOTE: When the Work List is set as "Not Used", order inquiry of the Work List
will not be performed. To perform order inquiry of the Work List, set
the Work List to "Used", using the setting program. Refer to
Chapter
11, Section 6.9: Work List
for information.
1.1 Order Inquiry Method
The analysis operation on a sample will be performed according to analysis information
ordered as below:
1. Perform inquiry of the Work List prior to analysis. Analyze the sample according
to the order request, if registered.
2. When the analysis order is not registered in Work List for that sample, the SF-3000
analyzes the sample.
Analysis operation is performed by each order inquiry made by Sample ID No. or
Rack-Tube Position No. according to the system setting. Refer to Chapter 11,
Section 6.9 Work List for the setting.
NOTE: If the data processing system model SF-DPS is installed with the
SF-3000, the real-time order inquiry of the host computer can be
performed. Contact your Sysmex sales representatives for
information.
S
smex SF-3000 Operator's Manual --- Revised September 1995
To Next Page
Loading...
Need help?
General
